Constructing surface from a set of contours

Started by yasmin_bd, Jan 24 2013 02:19 PM

Old topic!
Guest, the last post of this topic is over 60 days old and at this point you may not reply in this topic. If you wish to continue this conversation start a new topic.

You cannot reply to this topic

No replies to this topic

#1 yasmin_bd Members - Reputation: 121

0Likes

Posted 24 January 2013 - 02:19 PM

I have a number of contours which are oriented as shown in
the attached figure. I would like to construct surface from these set of
contours as defined by the red outline in the figure. Could any one give me some suggestions? Thanks

Attached Thumbnails

Sponsor:

Back to For Beginners

Old topic!
Guest, the last post of this topic is over 60 days old and at this point you may not reply in this topic. If you wish to continue this conversation start a new topic.