Archived

This topic is now archived and is closed to further replies.

This topic is 4947 days old which is more than the 365 day threshold we allow for new replies. Please post a new topic.

If you intended to correct an error in the post then please contact us.

Recommended Posts

I don' know what units DX uses. When I worked with some 3D modeling tools they give me options like feet,meters and etc. So which units I should use so that mine models fit best in the DX environment, And what is the default unit setup used by DX. MOV AL, 0x00 MOV AL, ME [edited by - rohitgonsalves on May 27, 2004 12:38:46 AM]

Share this post


Link to post
Share on other sites
There aren''t really units. Things are all relative. You could call it feet or miles, and it would work the same.

That said, I usually spec 1.0 == 1 meter, just for my own use. But, remember that going beyond +/- 1.0 begins degrading FP accuracy, if that matters to you. So tune it to your environment.

My spoon is too big.

Share this post


Link to post
Share on other sites