Sign in to follow this  

Might be the case Not enough clearance for the final orientation

This topic is 1604 days old which is more than the 365 day threshold we allow for new replies. Please post a new topic.

If you intended to correct an error in the post then please contact us.

Recommended Posts

Say a counter balance is to have 90 degrees snap onto the pallet. If there is some other obstacles or it is so close to the pallet so that there isn't enough clearance to turn. What should I do? My thought is to make backwards drive until it fits, but it takes up a lot of CPU cycles to do so. Like Local Repair, method....testing for so many paths until it finds one

Edited by lucky6969b

Share this post


Link to post
Share on other sites

I have no idea what you are talking about. Context? How about a picture or a diagram?

 

Say the red box is the pallet, the blue one is the counter balance

The black boxes are obstacles, the forks of the counter balance has to enter the pallet at a right angle.

Here I can't do so because they are too close.

Share this post


Link to post
Share on other sites

by counter balance you mean forklift? you can put one of the forks from the forklift in to the pallet at an angle and drive forward while turning to turn the pallet - then you can pick the pallet up.

 

Is this a programming question?

Share this post


Link to post
Share on other sites

This topic is 1604 days old which is more than the 365 day threshold we allow for new replies. Please post a new topic.

If you intended to correct an error in the post then please contact us.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this