• Advertisement

Archived

This topic is now archived and is closed to further replies.

Pentium III instructions ( 2 )

This topic is 5735 days old which is more than the 365 day threshold we allow for new replies. Please post a new topic.

If you intended to correct an error in the post then please contact us.

Recommended Posts

I am sorry for the delay to answer at the first topic, so I wrote this new one. As explained, I try using PIII instructions to use registers 128 bits of floating point. So, I installed the Service Pack 4 for Visual C++. After I installed the Processor Pack. Finally I tried to write a bit of code using __m128. So, I included fvec.h. But the compilation crashes. So far, I think that the Processor Pack installed a new compilater(or just several options) to understand assembler PIII. The problem comes from a file, called mmintrin.h, with : #ifdef __ICL typedef unsigned long long __m64; #endif The problem is that __ICL is not defined. However processor Pack should defines this value(''I''ntel ''C''ompi''L''er). So, do I have to set several parameters of Visual C++ or do I have to change parameters of compilation. Thanks.

Share this post


Link to post
Share on other sites
Advertisement
quote:
Original post by ArnoAtWork
I am sorry for the delay to answer at the first topic, so I wrote this new one.



I don''t quite follow your reasoning. Your first thread is still here, you just have to reply to it to put it back on the active topics page.

Share this post


Link to post
Share on other sites

  • Advertisement