# casefc3s

Members

2

120 Neutral

• Rank
Newbie
1. ## Method to Create a Mesh that is Inset by a Specific Distance

Well, this only applies to a simple polygon; it can be concave or convex, but not cross itself or have "holes". What I ended up doing was tracing the perimeter as all vertices in this circumstance are on the border of the poly plane. I took the normal of the 'edge' vector between the current vertex to the last, and then the normal of the edge vector from the current to the next, scaled each by the amount of inset needed and then stored that offset in a temp array, which was then applied after looping through them all. This wouldn't work exactly as desired for concave polys and would create a translation that was in the wrong direction, so I just did a 'point in polygon' check and if was out of the original poly's surface space I used the inverse of that translation to get it in the right position. This should work with 3d and complex polygons as well with a little more effort, I just didn't go that far this time. Thanks for the help everyone!
2. ## Method to Create a Mesh that is Inset by a Specific Distance

Alright, this is probably something fairly simple for those well-versed in mesh/vertex manipulation but I'm having trouble wrapping my head around a solution and haven't found anything else close enough to my problem to get me started in the right direction. I have an existing mesh plane, which could be either a rectangle or any convex/concave polygon. What I need to do is create an identical mesh, and then effectively scale that mesh down to create a border of 'd' distance between the edges of the original and duplicate mesh. Duplicating the mesh and its vertices/triangles isn't a problem, but properly scaling it is and I don't have enough experience in graphics programming to know how to scale all verts as a whole, still being centered on its original position, etc. Normally, I would simply scale an object down by hand in an editor until it "looked right" or do it in a 3d program, but in this instance it needs to be inset dynamically at runtime by an input value, and be physically correct. I'm hoping I posted this in the right place since it's a little more specific than a generic 'getting started' thread. Thanks for any help in advance, I've been racking my brain to try to figure it out but graphics programming isn't my forte and I definitely want to nail it down!